Sibelius 7 beams

[Deleted]

Hello! Have a problem in Sib 7 with part on screen shot...

How can i make this as on pic? (4/4) here 
i know i can write it in other way, but need this one... 
Thanks for any help

[Kevin]

Attachment Deleted

Hi and welcome to SOS!
I am sure if you go into the box with the note heads and run through them there is a place where you can do that. Does this help?

[Deleted]

tnx 4 fast answer, but....
i checked the whole list of available heads several times before placed a message here)
the problem is, there are half heads beamed as repeating 8ths, but if i use halfs no chance to place a beam and for 8ths there are no blank heads...
used headless type and heads from symbols, no luck, it makes a space between symbol (head) and beam

[Kevin]

Let me have a look into it.

[Kevin]

Go to Appearance> House Style> Engraving Rules click on Notes and Tremolos then touching stems. Voila!

You will need to enter four crotchets to do this and you then should end up with what you showed.

[Deleted]

done! Thank you very much!
and 1 more to go.... is there any way to make clef in cue size? )

[Kevin]

Go to the keypad click to the second level, bottom right you should have to whole notes with a flat sign. Highlight the notes in the score then click this.

[allanh]

An easier way is - enter 4 crochets (quarter notes) - highlight whole bar then - on the keypad click beams then tremolo with next note (enter key on key pad).

Allan

[Kevin]

That leaves a gap in the tremolos Allan (I think)

[Deleted]

Jan 29, 2014 14:24:37 GMT Kevin said:

Go to the keypad click to the second level, bottom right you should have to whole notes with a flat sign. Highlight the notes in the score then click this.

ok, but clefs stays the same size((

ok. nwm its not the point.
Thank you for your help!

[allanh]

Not when I do it Kevin. Full beam.

[Kevin]

Over to you Allan!

[Deleted]

Without touching stems it goes like that 
its ok, but needed them to touch stems)

[Kevin]

Is it okay with touching stems then?

[allanh]

You cannot change the size of the clef at the beginning of the page/sheet, but when you 'paste as cue' on the Home>Paste tab. Highlight first bar and Notations>Common>Clefs and choose the required clef. This will put a small cue size clef at the beginning of the bar.

I think this is what you are asking.

Allan

[Deleted]

got that... thank you..
btw if u change clef it goes smaller than in the beginning of the system, never noticed that...
found out how to make it smaller))) but its too small, so no additional operations needed...